SUCHAI payload¶
SUCHAI_Payload is the CubeSat Kit bus as the payload boards of the SUCHAI 2
and SUCHAI 3 satellites use it, from SPEL at the Universidad de Chile
(spel-uchile/Payload-PC104).
It is the same two units as CSK_Bus, with the
payload's names and electrical types on the pins it uses, so ERC can check
power and signal direction on a SUCHAI payload board.
These are the pins the payload assigns. Every other pin keeps its bus name and stays passive.
| Header pin | Bus signal | SUCHAI signal | Type |
|---|---|---|---|
| H1.1 | IO.23 |
CAN-L |
bidirectional |
| H1.3 | IO.21 |
CAN-H |
bidirectional |
| H1.9 | IO.15 |
I2C2_SDA |
bidirectional |
| H1.11 | IO.13 |
I2C2_SCL |
input |
| H1.19 | IO.5 |
RX |
input |
| H1.20 | IO.4 |
TX |
output |
| H1.32 | +5V_USB |
5V0_IN |
passive |
| H1.39 | TXD_MHX |
TXD |
output |
| H1.40 | RXD_MHX |
RXD |
input |
| H1.41 | SDA_SYS |
I2C-SDA |
bidirectional |
| H1.43 | SCL_SYS |
I2C-SCL |
input |
| H1.47 | USER0 |
OUT1_3V3 |
power in |
| H1.48 | USER1 |
OUT4_5V0 |
power in |
| H1.49 | USER2 |
OUT2_3V3 |
power in |
| H1.50 | USER3 |
OUT5_5V0 |
power in |
| H1.51 | USER4 |
OUT3_3V3 |
power in |
| H1.52 | USER5 |
OUT6_5V0 |
power in |
| H2.25 | +5V_SYS |
5V0 |
power in |
| H2.26 | +5V_SYS |
5V0 |
power in |
| H2.27 | VCC_SYS |
3V3 |
power in |
| H2.28 | VCC_SYS |
3V3 |
power in |
| H2.29 | DGND |
GND |
power in |
| H2.30 | DGND |
GND |
power in |
| H2.31 | AGND |
AGND |
power in |
| H2.32 | DGND |
GND |
power in |
| H2.35 | S1 |
RX2 |
input |
| H2.36 | S1 |
EPS_RX |
input |
| H2.37 | S2 |
TX2 |
output |
| H2.38 | S2 |
EPS_TX |
output |
| H2.45 | VBATT |
V_BAT |
power in |
| H2.46 | VBATT |
V_BAT |
power in |
The table is tools/suchai_pins.csv; tools/gensym.py builds the symbol from
it.