HAT+ checklist¶
Raspberry Pi's HAT+ specification (release of 5 December 2024) replaces the original HAT specification, which it marks deprecated. A board may be called a HAT+ only if it meets the specification's minimum electrical and mechanical requirements. This page lists them, and says which the templates meet for you and which are yours.
Required¶
| Requirement (specification chapter) | Templates |
|---|---|
| Plugs into the 40-way GPIO header, including the ID pins (6, 7) | Done. J1 is the full 40-pin connector. |
| An ID EEPROM on ID_SD and ID_SC, with 3.9 kΩ pull-ups to 3.3 V, holding data to the HAT+ EEPROM format (3, 6) | Circuit done; programming it is yours. |
| Nothing but the EEPROM and its pull-ups on ID_SD and ID_SC (2) | Done, and the schematic says so; keep it that way. |
| At least one mounting hole aligned with one of the Pi's four (7) | Done. All four are there. |
| If powered from the GPIO header, electrically compatible with the STANDBY state: 5 V present, 3.3 V off (1, 6) | Yours. Check every part on +5V for what it does while +3V3 is off, and anything that would back-feed +3V3. |
| Tolerates the weak pull-ups and pull-downs the Pi applies to every GPIO at power-on, in any order; provides its own pull where it needs a defined state (2.3) | Yours. GPIO2 and GPIO3 also carry about 2 kΩ pull-ups to 3.3 V on the Pi. |
| A Power HAT+ (one that powers the Pi) supplies at least 3 A at 5.1 V, 5 A recommended, and only sources current (4, 6) | Yours, if your board powers the Pi. It then also needs a Power class EEPROM address; see address class. |
Recommended¶
| Recommendation (chapter 7) | Templates |
|---|---|
| Stays clear of the Pi 4 and Pi 5 PoE headers | Yours for parts and their leads; the templates put nothing in that area. |
| Spacers of at least 15 mm, 16 mm ideal, so a Pi 5 Active Cooler fits; more if the HAT has parts underneath | Depends on the template: possible with through-hole, not with the SMD socket. See Templates. |
| Does not block access to the camera, display and PCIe flex connectors | Done for camera and display: the outline keeps the flex slot and cut-out. Keep them unless your board cannot. |
Naming¶
A HAT+ should use "HAT+" in its name. One that works only with some Pi models must say which, on the board and in its documentation; one that stacks with another HAT must say so in its documentation (chapter 5).