lampshades

3D-printable lampshades in OpenSCAD, printed in vase mode and lit from inside. Most are Matthew Seabright’s, with their mounting parts; two more come from other designers. Each design is a module you can resize, and the examples show every one in 3D.

A rope swirl shade, lit

The designs

Designs By Licence
Shades: double rotated octagon and pentagon, fish tail, golfball, pineapple, rope swirl, rotated star, screw compressor, triple spring, turbine, noise. Mounting: adaptor, base, feet. Photos. Matthew Seabright MIT
Gyro lamp shade Harald Andersson CC BY-NC-SA 4.0
Lamp shade generator seasick CC BY 4.0

Matthew Seabright’s designs are taken from mjseabright/lampshades at commit 5c20d70 (2026-08-31), unchanged. That repo is where they are developed, and their STLs are on Printables.

Make one

Each shade lives in its own folder. <design>.scad holds the shape as a module, and the files beside it, such as turbine/turbine_small.scad, set the dimensions and add the hole for the mount. Open one of those in OpenSCAD to render a shade. geometry_functions.scad and mounting_functions.scad hold the shapes the designs share.

Rendering stacks one thin slice per layer, so a fine layer_height is slow. Raise it while you try out a shape and set it back to 0.2 mm for the final render.

The noise shade is generated: noise/noisey_generator.py writes noise/noisey.scad, and the parameters are at the top of the script.

The gyro shade and the generator are single files with Customizer parameters.

Mounting and printing

The shades fit a lamp base with an E14 bulb and the usual ~28 mm threaded shade ring. Print the shade in vase mode (one wall, spiral), and print the adaptor normally, with supports, then glue it into the bottom of the shade. bases/ and feet/ hold a low-profile stand for the larger shades.

Settings that work for vase-mode shades: PETG (PLA can warp near a hot bulb or in sunlight), 0.2 mm layers, 0.6 mm line width, 6 solid bottom layers. Fuzzy skin suits several of the designs.

Gluing the adaptor into a shade

More pictures are in photos/. The story of designing and selling these is on Matthew Seabright’s blog.

Licence

Each design keeps its designer’s licence, as the table above gives it. The README, the examples and the build are MIT, under LICENSE.


This site uses Just the Docs, a documentation theme for Jekyll.