segmented-hose-scad

One segment of a ball-and-socket hose, the kind used to aim coolant or air, modelled in OpenSCAD. Each segment has a socket at the bottom and a ball on top that snaps into the next segment’s socket; two slits let the ball flex, and a bore runs through both. Print as many as you need and push them together.

Three segments in a chain, the top ball slit to flex into a socket

Use it

Open segmented_hose.scad in OpenSCAD and set the parameters in the Customizer, or use the module from another design:

use <segmented-hose-scad/segmented_hose.scad>
$fn = 128;

segmented_hose_segment(coupling_diameter = 12, bore = 6, clearance = 0.1);
  • coupling_diameter is the ball’s diameter and the socket’s. thickness is the wall round the socket, bore the hole through the segment, slit_dim the width of the ball’s two slits.
  • clearance is added to the socket’s diameter: 0 (the default) is a tight fit that relies on the print; more is looser.
  • The factors set the proportions as fractions of coupling_diameter: the distance between the socket’s centre and the ball’s (center_distance_factor, which is also the chain’s pitch), and how much of the ball’s top and the socket’s bottom is cut off.
  • A segment stands on z = 0 with its axis on z. segmented_hose_pitch(), segmented_hose_height() and segmented_hose_mouth() give the chain’s pitch, a segment’s height and the width of the socket’s mouth.
  • segments in the Customizer previews a straight chain.
  • From another file, set $fn yourself: a used file’s own $fn doesn’t reach its modules.

A segment is refused, with a message, if its bore leaves no wall in the ball, or if the socket’s mouth would be as wide as the ball, which would then fall out.

Print segments upright, socket down.

Checks

just test takes about 2 s on OpenSCAD 2026.10.15. For three sizes, it renders a segment with warnings treated as errors and checks that it’s one solid of its outside size, standing on z = 0, and that the socket’s mouth is narrower than the ball. It then sets a second segment one pitch above the first and checks that, at a clearance of 0.2 mm, its ball sits in the socket without overlapping it, and that at -0.2 mm it does overlap. It also checks the two refusals.

just images renders the picture above.

Plans

Threaded end pieces, to fix a line to something, are tracked in #1.

Licence

MIT; see LICENSE.

Loc-Line is a trademark of Lockwood Products. This project isn’t affiliated with Lockwood Products, and its parts aren’t claimed to fit theirs.


This site uses Just the Docs, a documentation theme for Jekyll.