scadsculpt

Generative sculptures in OpenSCAD. Each is one file with its parameters in the Customizer, built as a single polyhedron (or three, for the gargoyle) from closed-form curves, and set on the bed.

   
The chiral sonic bloom: a tube that loops round a wavy ring The crystal helix knot: a faceted tube tied in a knot
chiral_sonic_bloom.scad: a pulsing tube swept round a wavy ring, with a twist crystal_helix_knot.scad: a faceted tube tied in a Lissajous knot
The hyper-gargoyle: a red spine wound with green and yellow vines The flame plumes: five tongues of flame twisting to a point
hyper_gargoyle.scad: a rising spiral spine with two vines wound round it flame_plumes.scad: tongues of flame twisting faster towards a point

Use it

Open a file in OpenSCAD and change its parameters in the Customizer. Each sculpture sits with its lowest point on z = 0. The tube sculptures touch the bed at only a few points, so they print with supports, or resin.

Checks

just test takes about 2 s on OpenSCAD 2026.10.15. It renders each sculpture with warnings treated as errors and checks that it’s one solid with its faces pointing outward (a positive volume), sitting on z = 0, at the size it has always had; and that the flame refuses impossible input.

just images renders the pictures above.

Origin and licence

flame_plumes.scad was first modified from the flame sculpture in Jochen Kerdels’ Mastering OpenSCAD, which states no licence. It is now new code with a different method, a lobed cross-section that twists and narrows, and only the idea comes from the book. The earlier version is in this repository’s history.

MIT; see LICENSE.


This site uses Just the Docs, a documentation theme for Jekyll.