rpi-hat-kicad¶
KiCad 10 project templates for a Raspberry Pi HAT+: the board outline, mounting holes, 40-pin GPIO connector and the ID EEPROM a HAT+ needs, placed, routed and passing DRC, ready to design on.

What you get¶
| Feature | What it is |
|---|---|
| Two templates | One with a through-hole 2×20 GPIO socket, one with a Samtec surface-mount pass-through socket. |
| The ID EEPROM | A CAT24C32 at address 0x50 with its pull-ups, decoupling, write-protect test point and write-enable jumper, as the HAT+ specification asks. |
| Every GPIO pin labelled | A global label on each free pin, GPIO2 to GPIO27: place the same label in any sheet to use the pin. |
| Checked boards | Both templates pass DRC with schematic parity; ERC lists only the 26 GPIO labels you have not used yet. CI re-checks this on every change. |
Start here¶
- New HAT? Create a project from a template.
- Which template? Through-hole or SMD: it decides how high your board sits above the Pi.
- Calling it a HAT+? The HAT+ checklist says what the template covers and what is still yours to do.
Credit and licence¶
Derived from RPi_Hat_Template by Dave Vandenbout, which laid both connectors and both outlines over each other for the user to delete one. The GPIO symbol and the socket and header footprints come from his RPi_Hat.pretty.
MIT licence; see LICENSE. Raspberry Pi is a trademark of Raspberry Pi Ltd; this project is not affiliated with it.