prusa-mk3-frame-support

A printable version of the Prusa MK3(S+) frame support…in case you lose yours like I did.

This is a scad implementation of the sheet-metal frame support bracket that comes with the Prusa MK3(S+) kit, if you’re missing it. The printed part:

The printable frame support: a tapered, ribbed block with two slots at the wide end and two holes in the side wall

Photos of a printed one, on its own and installed, are to come (#2).

Files

  • frame_support.scad — parametric source; every dimension is a named variable at the top.

To get an STL to print, after changing any parameter you want:

openscad -o frame_support.stl frame_support.scad

Dimensions

The printed part keeps the sheet-metal bracket’s footprint and mounting points, and replaces the thin L-profile with a pocketed, ribbed block.

   
Footprint 80 mm wide at the slotted end, tapering to 40 mm over 206 mm length (taper starts 35 mm in)
Height 22.2 mm (the original flange height)
Floor / walls / ribs 5 mm
Slots 2 × 3.3 mm wide (M3), 54 mm apart, open at the wide end
Side-wall holes 2 × Ø4.5 mm (M4), 117 mm apart, 11.2 mm up, with Ø16 mm head clearance on the inside
Chamfers 4 mm × 45° where pocket floors meet the walls; 0.5 mm on the slot edges at the bed

Printing

Print flat-face down, as modelled; no supports are needed.

Checks

just test takes under a second on OpenSCAD 2026.10.15. It renders the part with warnings treated as errors and checks that it’s one solid of the size above; that each slot and side hole is open, with a probe a little narrower than it passed through where it should be.

just images renders the picture above.

Licence

MIT; see LICENSE.

Prusa is a trademark of Prusa Research a.s. This project isn’t affiliated with Prusa Research; the part is made to fit their printer.


This site uses Just the Docs, a documentation theme for Jekyll.